The 30-Minute Wait Is the Real Problem
A 6-gallon RV storage tank gives you one shower, then makes the whole rig wait — roughly 30 minutes to reheat before anyone else can rinse. A tankless RV heater ends that: it heats on demand, so the whole family showers back-to-back, and a dish cycle or a dog wash in between does not drain a tank.
Why Tankless Changes the Math
Tankless means no stored water to reheat and no tank taking up bay space. Multiple outlets can run in sequence without the cold wait. The unit drops into a standard 15×15 inch cutout (18×18 oversized where fitted), so a retrofit stays a weekend job, not a renovation. It starts from as little as 2.5 L/min and runs across 0.01–0.8 MPa, with outlet temperature set 32–52 °C.
6-gallon tank Tankless shower ~30 min reheat wait next shower shower continuous next shower no recovery wait
Schematic, not to scale. A storage tank forces a reheat gap between users; tankless heats on demand, so the whole rig showers back-to-back.
What to Ask Your Supplier
- Tank or tankless, and what is the recovery time on a tank model? (Tankless = no recovery wait.)
- What cutout size does it need — 15×15 or 18×18? (Standard 15×15, oversized 18×18.)
- Minimum start-up flow and pressure range? (2.5 L/min; 0.01–0.8 MPa.)
- Heat exchanger material? (Ours: lead-free stainless steel.)
Practical Pitfalls
- This is an embedded RV unit — the shower goes inside the bathroom, not outside the vehicle.
- Do not treat a portable unit as an "upgrade" for a rig that already has a 15×15 bay; the embedded model uses the existing cutout and services.
- Size BTU to your coldest expected inlet temperature, not your summer trips.
Bottom Line
Swap the tank for tankless and the 30-minute wait disappears. The whole rig gets endless hot water, and installation still fits the cutout you already have.